• Measuring range: 10 - 900 Hz
• Accuracy: ± (1% of rdg. + 4 digits)
• Measurement of the oscillation frequency of the drive belt
• Intuitive controls
• Calculation of the tension force
• Display of the belt tension in N
• 6 menu languages
• Memory for 750 measured values
• Sensor on gooseneck
• The input of belt length and belt mass

Memory for 750 measured values / graphic display / easy operation / multilingual menu / measurement in Hz and N

The belt tension meter is an optically measuring maintenance tool for determining the belt tension force. This belt tension meter consists of a display device and a sensor head attached to a semi-flexible gooseneck. The advantage of the gooseneck is that the sensor head can be flexibly positioned. Due to the mobility of the gooseneck, the sensor can measure the strand force even in hard-to-reach places. The belt tension measuring device measures the belt tension (in Newton) and the belt frequency (in Hz) of the belt in the stationary state.

A small impulse on the belt is sufficient to set the belt vibrating. The belt tension meter measures with the sensor the natural frequency of the belt generated in this way and visualize it on display. The belt tension meter can directly determine the actual tension (in Newton / Pound Force) of the belt from the belt frequency combined with the optionally entered belt length and mass. However, entering this data is not necessarily required to carry out the measurements directly with the belt tension measuring device. The measurement units in the device can be switched between N (SI unit) and pound-force (US unit).

The reading is always shown as the belt frequency in Hz on the display of the belt tension measuring device. The intuitive graphic menu is visualized on the high-contrast display of the belt tension measuring device in six different languages. Up to 750 data records can be stored in the memory of the belt tension measuring device. The belt tension measuring device is delivered completely ready for use. The scope of delivery includes the handheld device, the standard sensor with a gooseneck, a magnetic holder, batteries, and an operating manual. To increase the flexibility during the measurement, the following items are optionally available to the belt tension meter: an external sensor head with a spiral cable, a device hard case, a frequency mallet, and a tripod.

Areas of application for Belt Tension Meter

The belt tension measuring device can measure the belt tension of timing belts, ribbed belts, and V-belts. Belt tension is essential for the belt drives' maintenance, installation, setting up, and repair. The belt tension must be controlled regularly over the entire running time and adjusted if necessary to ensure the maximum possible service life of all the machine components in the periphery of the belt. The preload force must be selected according to the parties to be transmitted.

Principally here applies, the greater the forces to be transmitted and the greater the belt speed during operation, the greater the preload forces that must be selected. At the same time, it is necessary to ensure that the belt tension is not set too high, since otherwise, the bearings of the belt drives can be affected and, at the same time, the belt wear increases, which may cause belt cracks. At the same time, too low belt tension can also cause damage when, for example, teeth skipping or belt slipping occurs. Because of that, it is essential to determine the belt tension or the preload force with a belt tension measuring device. This may help significantly reduce the follow-up costs due to the unplanned standstill and downtime caused by the bearing damage or defective belts. Therefore, a belt tension measuring device is suitable for industrial production, motor technology, stepper motors, machine and tool construction, or maintenance and repair.

What's in the Box

• (1x) Force Gage PCE-BTM 2000
• (1x) Standard sensor head
• (1x) Magnetic holder
• (3x) 1.5 V AAA battery
• (1x) Operating instructions
• (1x) Carrying bag