Fluke 710 mA Loop Valve Tester

Features and Specification

• Valve test procedures that deliver Good, Marginal or Bad assessment of a control valve
• Generic HART communication
• Best-in-class mA accuracy at 0.01 % measurement or source value
• Compact rugged design
• Intuitive user interface with Quick-Set knob for fast setup, easy to use
• Ranges mA (0 to 24 mA) and Volts (0 to 30 V dc)
• 24 V DC loop power with mA measure mode (-25 % to 125 %)
• Resolution of 1 µA on mA ranges and 1 mV on voltages ranges
• Built in selectable 250 ohm resistor for HART communications
• Simple two wire connection for all measurements
• Auto shutdown to conserve battery life
• Variable step and ramp time in seconds

The Fluke 710 Valve Testing Loop Calibrator is a tool specifically created to facilitate swift and straightforward testing of HART smart control valves. It comes with pre-installed test procedures and a user-friendly interface, enabling users to conduct valve tests with ease. The device provides immediate diagnostic results from the valve test quick-check, aiding in making expedited maintenance decisions. The health status of the valve, indicating whether it's in good, marginal, or poor condition, is quickly determined, assisting users in deciding if further maintenance is required.

Featues Built-in HART modem to communicate the following HART commands:

• Read sensor PV information
• Read PV output information
• Read and write PV unit type, tag ID name, descriptor, and message
• Read and write PV ranges (upper and lower)
• Enter/exit fixed current mode
• Set zero offset
• Trim DAC zero (mA output 4 mA)
• Trim DAC gain (mA output 20 mA)

What's in the Box

• 710 mA Loop Valve Tester
• Stackable test lead set
• Extended tooth alligator clip set
• TP220 test probes
• AC280 SureGrip hook clips
• Lemo to USB upload/download cable
• ValveTrack software (free download)
• Softcase
• Six AAA batteries (installed)